What did you do to your GE fit today?
This shop called 1320 in my area sells these leds with heat sinks on them. Lol!! But compared to stock; literally night and day. Haha!
Not entirely sure when yo use them...I have the blue/black OEMs, my 3d Aries mats and now these.
I like the 3D mats due to their solid build and I have 2 dogs and we know how the carpet/upholstery is a magnet for anything, especially dog hair. So they work great regarding that...they are just slippery and not entirely comfy.
OEMs/Mugens will collect dog hair like nobodies business....maybe I just have to alternate from time to time haha.
Yeah those LED's are insanely bright. even just using the center dome light looks like it outputs enough light for the whole car lol.
Researching vinyl for my tail lights...have done flat surfaces tons of times...but never a curve this drastic.
Very nice!
Getting my rear fenders rolled today. Hope it's enough to stop the rubbing. Not really wanting for a pull in the rear. If rubbing still persists....may have to be cool like everyone else and get new wheels.
Getting my rear fenders rolled today. Hope it's enough to stop the rubbing. Not really wanting for a pull in the rear. If rubbing still persists....may have to be cool like everyone else and get new wheels.
I'm barrowing my friends fender roller too! Haha!!
Last edited by mikes-ge; 04-22-2017 at 01:16 PM.
LOL I was wondering what "narrowing" meant in regards to a roller. Darn autocorrect.
I'm having some guy come by to do it today. Figure he's been doing it for 5+ years and can knock it out in about an hour.
I'm having some guy come by to do it today. Figure he's been doing it for 5+ years and can knock it out in about an hour.
I didn't do any car stuff, but I finally laid my pavers today. After the gravel, sand and then laying down 275 bricks I'm beat to shit!! Tomorrow, roll fenders!!! Hopefully I can do the valve cover gasket on Monday!
Go slow and use a heat gun. Including lifting and lowering the car, it shouldn't take more than an hour and change. I had the car on jacks already for him and it took him about 45 minutes to roll both. Hopefully get a drive in today or tomorrow to "test" it. But I'm 95% sure the rubbing will be gone.
Plan to wash and vacuum the car as well as purchase the vinyl for my tails.
Compressor (OEM Used) - 100
Condenser and Receiver Dryer (eBay) - 40
High side Aluminum Pipe and Sensor (HondaPartsUnlimited) - 75
2 Cans of R134a (one was wasted during repair) - 40
Not that bad really, didnt need to fix the expansion valve. Blows super chill now, especially with 100 degrees coming up soon here in PHX.
Condenser and Receiver Dryer (eBay) - 40
High side Aluminum Pipe and Sensor (HondaPartsUnlimited) - 75
2 Cans of R134a (one was wasted during repair) - 40
Not that bad really, didnt need to fix the expansion valve. Blows super chill now, especially with 100 degrees coming up soon here in PHX.