Anyone got the Skunk2 Short Shifter
#4
I bought the h-fit short throw shifter.
install was a bit of a pain, but the second time around it would probably only take me 20 minutes, so really and truly it's not hard.
the instructions are good and the throw is definitely improved.
install was a bit of a pain, but the second time around it would probably only take me 20 minutes, so really and truly it's not hard.
the instructions are good and the throw is definitely improved.
#8
Here's the Skunk2 short shifter thread.
www.fitfreak.net/forums/skunk2-racing/15395-skunk2-short-throw-shifter.html
I installed mine about 3 months ago, and I've been loving it since.
www.fitfreak.net/forums/skunk2-racing/15395-skunk2-short-throw-shifter.html
I installed mine about 3 months ago, and I've been loving it since.
#10
I have the SK2 SS and I love it. Getting the plastic cap off the ball of the shifter is the most time consuming and hard part but all you need is a flat head screw driver and some elbow grease.
The shifter sits about 1/4-1/2" higher than stock - yes higher but the throws are shorter. It shifts a little notchy compared to stock.
The shifter sits about 1/4-1/2" higher than stock - yes higher but the throws are shorter. It shifts a little notchy compared to stock.
Thread
Thread Starter
Forum
Replies
Last Post
DecalDude
Merchant Group Buys and New Product Sales
15
07-17-2011 07:07 PM
Skunk2TS
Fit Engine Modifications, Motor Swaps, ECU Tuning
3
08-28-2007 10:11 PM