i started this last week and have not finished it. i took better pics and will touch up on the parts that i kinda skipped. ive been really busy with work but the car sits with no fenders and bumper on it.

starting to remove the fog lights


took off the bumper so i could remove the headlights


removed the headlights (after this start removing the fender lining.)



the hardest part of removing the fender is the bolt that sits under the plastic at the bottom of the windshield. ( ray told me about that one)
you have to tug on the plastic a little to pop off the clips that are holding it on



after you remove that bolt there is one underneath the sidskirt, headlight and a few in the engine bay



when i took off the fender there was this black box thing(have no clue what its for) it was getting in the way of where the fender brace mounts so i had to take it off.( also note the plastic cover that is sitting on the front of the door needs to come off too)




and these are the fender braces waiting to be put on

 

fantastic

subscribed for interest

 

so is it doable?

 

of course it is

only problem i ran into was how to mount the front piece cause you cant get behind the frame to put in the nut. i will figure something out.

 

hey, while your fender is off the car, could you sell me your passenger side please?

 

pass side fender? no way haha what would i use

 

that front strut tower bar looks good. better than a lot i have seen so far

 

thanks. easy install too

 

good DIY.but serious those fender bars are not that useful for FIT.

Good coilover setup, rear sway bar will be enough.

 

did you ever get the fender brace in?

 

good coilvers, rsb will not be enough i can promise you that.

 

started on it again yesterday. should be in by the end of this week

 

redrumm, did you manage to finish the installation? cos i'm thinking about getting the UR fender braces too - thanks!

 

lol did you ever finish?

 

yeah lol i just never updated

 

have you see an improvement?

 

yeah any improvement?

 

I've installed them too...it made a big difference on the handling...
here is my DIY
https://www.fitfreak.net/forums/album.php?albumid=310

 

Where can I buy these? I wanna get a set on friday.

 

redrumm sells them...