Bthasht's Trail
#23
Yep, that makes sense. Thanks man! I've got the S-Techs and think they sit too high in the back, would rather be level. +rep for you!
#25
Tsudo Cat Back Exhaust is on along with Aspec test pipe wrapped.
Here is the exhaust clip. Camera was close to it on start up so has a different noise. This thing is loud and im gonna reinstall factory cat to test it that way next. I do love it though....
YouTube - ‪2008 Honda Fit‬‏
Here is the exhaust clip. Camera was close to it on start up so has a different noise. This thing is loud and im gonna reinstall factory cat to test it that way next. I do love it though....
YouTube - ‪2008 Honda Fit‬‏
#27
Undercoated rear wheelwells. Got rid of that ugly well look for something more clean.
Here are a couple shots from a local show last weekend with some peoples...
Took test pipe off, and reinstalled factory cat. Sounds alot better now. Not as loud, i can actually drive it now.
YouTube - ‪2008 Honda Fit Exhaust‬‏
Here are a couple shots from a local show last weekend with some peoples...
Took test pipe off, and reinstalled factory cat. Sounds alot better now. Not as loud, i can actually drive it now.
YouTube - ‪2008 Honda Fit Exhaust‬‏
#30
Look'n betta every time that I see it B......
#38
^^ go to the exterior section and download the side marker template. There is a diy thread on there. I just used specs and made my own template. Tape it off, lay index card template on, draw it out and cut with dremel. As for the duckbill I taped off and measured a million times. Then drilled two holes to fit. I used three m tape to cover stock holes. Worked great. Ryan roland did a diy on that as well.
#39
Nice i love the Fit couple of questions one is how did you like the skunk springs. I have had mine for about 6 months now and have not installed them i'm scared i will rub and hate them. Also how did you paint the runners in the engine gold? Did you just tape every thing else off?
#40
^^ The skunk springs were great. On stock wheels you will not rub at all. They ride good and handle good as well. Put them on you will love them. I switched to tein springs to go lower then skunks.
Now for the intake. I removed the whole thing to install a password jdm gasket. While it was apart I painted the intake high heat gold. Turned out very nice. Matches perfect with my password jdm fender washers.
Now for the intake. I removed the whole thing to install a password jdm gasket. While it was apart I painted the intake high heat gold. Turned out very nice. Matches perfect with my password jdm fender washers.