SOOOOOOOOOOO DOPE - LOVE THE HOOD!!!!!! NEEDS MOR RUST!

Is this a base w/sport bumper? or sport with a base hatch? it's interesting more people aren't swapping these things among other fit freak members

 

It's a sport with a haircut... holes were fixed at a body shop like it wasn't there

 

Wheels look good. Which country is that from?

 

Amazing FIT's here. Here's my simple set up:

VarrsToen V3 15x8 +25
195/55/r15
Maxspeed Lowering Springs 1.5
DownPipe
Vinci Volt and Rpm Gauge

Been through a few set of rims in a year. Here goes.

Started off with OZ 14' Rims










Then after that I sold my OZ's then bought a new set of Volk Ray rims





Then Bought this last set of rims VarrsToen V3 15x8 +25 plus the Maxspeed Lowering Springs

 

you mean this right? https://fbcdn-sphotos-h-a.akamaihd.n...05781946_o.jpg it's here in the US, Chicago

all legit wheels on those cars. my Fit are on BBS

 

I know it must be posted elsewhere what are the specs on your BBS?

 

^they're 16x7 +42 but ran them with 10mm spacer on front and 15mm on rear, fenders are rolled with a slight pull.

the pull messed up the lines of the fender and bumper... fixed it with spacers inside the mounting points

 

Thanks so you are now et32 front and et27 rear with the spacers?

 

correct. I'll be pushing it more with my new wheel setup... 17x8.5 +32/F +20/R fender will be flared is what I'm planning instead of a pull.

 

The metal flared or adding fender flares?

 

the fender itself will be custom flared to keep the lines, no bolt-on or pre-made flare.

 

That should be nice, making it look like the car was actually built that way as opposed to a add on. Can not wait to see the end results. I always felt that if I was going to go to a expensive set of wheels with a lower offset and maybe wider. It would be best to have a professional body shop do the work rather then do myself.

 

washed the yazz to get it ready for the hellafit meet this weekend



also snapped a pic of the new shifter setup!

 

circuit hero?

 

Sorry about the confusion I was trying to find out where the CAR is from as it's not a USDM Fit.

 

Dam not much time left to get that hood fixed before the show.

 

Looks like it, right? they are just generic ebay parts. less than $20 for both parts shipped

 

up

 

What country are you in? Why is your Hazard button off to the right compared to the USDM spec with it closer to the steering wheel.

 

This my Daily 07 GD on 15x8 works nezart mesh.