Showcasegd3's Slammed base
#108
WHAT? a drifting fit? hahah just add a little bit of smoke
love the low - i have problems getting my car up and i'm only dropped on df210s.
how do you jack up your car? i have to use two jacks. jack it up on the side jack points and then stick another jack to put it on the front support of the car b/c its all the way in. is there a better way to do this?
love the low - i have problems getting my car up and i'm only dropped on df210s.
how do you jack up your car? i have to use two jacks. jack it up on the side jack points and then stick another jack to put it on the front support of the car b/c its all the way in. is there a better way to do this?
#109
NO F-ING wonder you're sooo low! lmao I've been eying you and Illmatic for the longest time I finally get my coil overs on and realize you're on 14's! lol, the smoke and mirrors have been lifted LOL! Great looking car man.
#117
I'm calling BLUFF on this pic.... that's not your ride height you pulled up onto the curb to make the "picture" side look DUMPED
I apologize if I'm wrong
If that IS your ride height I need wheel/tire sizing, rear alignment specs, and how much of the bumper support your cut out lol
I apologize if I'm wrong
If that IS your ride height I need wheel/tire sizing, rear alignment specs, and how much of the bumper support your cut out lol
#118
when i was that low, i was on 15's. 195/50/15 tires, 35 offset.i shaved the crab out of my rear fenders. and the tab was just held on by a paper clip, the screw that was in place of course was rubbed off. i did the washer trick for the rear to add some camber, i think it was a total of 6 washers that helped out.
#119
Well I didn't want to wait lol so last night I busted out the ole grinder... sure enough thats all it took. I must appologize for my "BLUFF" post earlier, once in a while my mouth gets ahead of my brain... as for the washer trick, I didn't know about that at the time so I had my allignment shop install some Ingalls rear camber/toe shims, same outcome only I spent double probably lol
#120
I'm calling BLUFF on this pic.... that's not your ride height you pulled up onto the curb to make the "picture" side look DUMPED
I apologize if I'm wrong
If that IS your ride height I need wheel/tire sizing, rear alignment specs, and how much of the bumper support your cut out lol
I apologize if I'm wrong
If that IS your ride height I need wheel/tire sizing, rear alignment specs, and how much of the bumper support your cut out lol
rota slipstreams 15x6.5 205/50R15 +38 offset