after pulling off my bumper once again because of the hassle of the HIDs I got from Ebay, I went back to stock halogens. lol

anyhow my buddy helped me out to put some other things in.

T1R intake, Braille battery w billet mount, Cusco strut bar and Spoon reso cover. We mounted the battery like that cause it was the flattest spot on the base that I could screw down the stand. I'm going to get a large flat piece of steel later on then screw into that. That way I can move the battery over some.

Intake definitely is louder than stock box but does help the car pick up faster. I'm going to put some 16 inch spoons as soon as I get some tires. Next weekend is a drop on T1R coilovers.

 

yeah i hooked up the IAT. it was too short so I had to extend the wires. I soldered and heat shrinked. This intake was AJ's prototype unit so the hole seems to be too far away.

the entire battery mount is billet aluminum. It actually was in my AE86 but I don't drive it much so I decided to put in the Fit. the Fit battery is still smaller than stock and is light enough for that car.

 

Looks good. that's a baller a$$ intake!