Short shifters, again
#21
Install Question
Question, I got the Skunk2 adapter from a member here, but it didn't come with directions.. So, I was supposed to remove the rubber mounts and replace them with the metal ones from Skunk2? The metal spacers aren't supposed to be in addition to the stock mounts?
I'm assuming this is correct because the screws weren't long enough to join the two pieces, but I want to make sure I have it installed properly.
And doesn't this picture show the metal spacers from Skunk2 added to the bottom of the shifter assembly with the rubber mounts still attached?
https://www.fitfreak.net/gallery/alb...er_adapter.gif
I'm assuming this is correct because the screws weren't long enough to join the two pieces, but I want to make sure I have it installed properly.
And doesn't this picture show the metal spacers from Skunk2 added to the bottom of the shifter assembly with the rubber mounts still attached?
https://www.fitfreak.net/gallery/alb...er_adapter.gif
Thread
Thread Starter
Forum
Replies
Last Post