Custom glassed in subwoofer enclosure started
#11
Using a Pioneer TS-SW1041D. Used 2 of them in my truck and they work very well, especially for the cost and space requirements. It will be driven by an Alpine PDX-1.600
The amps, a spot for a nitrous bottle, etc will be flushed into the floor in the spare tire well. (My other car hasn't had a spare for 10+ years either... picture below)
My goals are ergonomic integration in most of my installs. Making the car appears mostly stock and retaining as much usability as possible, while going for optimum sound quality. I'm not going to go as nuts in the Fit as I did in my GTP. I competed and placed in the Top 10 at Nationals in 1998 (Sound Quality), then judged in 1999.
The amps, a spot for a nitrous bottle, etc will be flushed into the floor in the spare tire well. (My other car hasn't had a spare for 10+ years either... picture below)
My goals are ergonomic integration in most of my installs. Making the car appears mostly stock and retaining as much usability as possible, while going for optimum sound quality. I'm not going to go as nuts in the Fit as I did in my GTP. I competed and placed in the Top 10 at Nationals in 1998 (Sound Quality), then judged in 1999.
Last edited by mnapuran; 04-22-2008 at 09:31 AM.
#15
oh man i just read your signature. 07 cbr ? is it pearl white?
haha its a debate between audio and exterior work , or pick me up a bike .
so so hard now. but deng, your gtp looks nice in the trunk heh
haha its a debate between audio and exterior work , or pick me up a bike .
so so hard now. but deng, your gtp looks nice in the trunk heh
#16
Too bad you live soooooooooo far away. I am thinking about selling my bike in the summer, but i want it to have a good home.
Last edited by cavie187; 04-22-2008 at 10:19 PM. Reason: I can't spell.
#17
I'ma have to take a shot of my setup in the car. Altho now that i've seen what ur up to i'm considering the same thing. Because i've really been starting to get aggravated with all the space my stuff takes up. And i miss being able to carry chit in the back
#19
Did my last internal layer of fiberglass on the enclosure yesterday. Measured out the total air space today, and it worked out to a just about perfect .7 cuft
I'll be busy the next few days, so won't get to do more work on it probably until Monday or so.
I'll be busy the next few days, so won't get to do more work on it probably until Monday or so.
#20
Hope you updated the blog too...
*checks blog link*
Thread
Thread Starter
Forum
Replies
Last Post
Jamy
2nd Gen GE8 Specific Fit Interior Modifications Sub-Forum
3
02-28-2011 05:34 AM