DIY Guide: Wiring lights along w/ the dome light.
#101
Some US company.
Here are all my blue interiors
https://www.fitfreak.net/forums/fit-...iny-again.html
A bit brighter but waaaaaaay more cool.
Here are all my blue interiors
https://www.fitfreak.net/forums/fit-...iny-again.html
A bit brighter but waaaaaaay more cool.
#105
thanks for the wiring on this -- its all i needed to get started on my additional lighting -
The plug in the lower left corner of the switch is an always on power. For JUST adding lights to work with the dome light, this is an easy spot to plug in. Power on bottom left, Ground on top right. However, it's the ground on the top right that is switched on and off, that's the important one.
The plug in the lower left corner of the switch is an always on power. For JUST adding lights to work with the dome light, this is an easy spot to plug in. Power on bottom left, Ground on top right. However, it's the ground on the top right that is switched on and off, that's the important one.
#106
Anyone know the load limit for the GE dome light circuit?
I have door sill LEDs already attached in parallel and want to add some small strips in my door handles.
The strips are 4.5ma each, think it'll be a problem to install 4-8 of them? Keeping in mind what I already have installed.
I have door sill LEDs already attached in parallel and want to add some small strips in my door handles.
The strips are 4.5ma each, think it'll be a problem to install 4-8 of them? Keeping in mind what I already have installed.
#108
Pics:
The wiring harness took 1.5 hours and the install another 1.5 hours. I used the convoluted tubing under the dash and under both front seats.
I tucked the wires into the console by removing the 2 front screws and removing the rear screws. Once tucked under the console, tightened up the screws and everything is quite tidy and out of sight except for where it sneaks out briefly to the convoluted tubing.
Pretty much same install as my 2015 Fit here:
#110
Help vios dome light wiring
well, since my GF lets me mod her Fit (she just doesn't want me to get crazy) I decided to do the footwell lighting.
It was a PIA. I was not able to get my 14 gauge jumper wires to stick. So I just stuck in the 10 gauge wires from my LED strips (Pilot 10" LED strips from Pep Boys/ $19.99 each). I ran the wires underneather the paneling. So you cant see it. It came out pretty good. But took me longer than I expected.
Here's the pics:
Attachment 79108
BIG THANKS to jlor for the DIY info.
It was a PIA. I was not able to get my 14 gauge jumper wires to stick. So I just stuck in the 10 gauge wires from my LED strips (Pilot 10" LED strips from Pep Boys/ $19.99 each). I ran the wires underneather the paneling. So you cant see it. It came out pretty good. But took me longer than I expected.
Here's the pics:
Attachment 79108
BIG THANKS to jlor for the DIY info.
Thread
Thread Starter
Forum
Replies
Last Post
kitkit201
Fit Interior & Exterior Illumination
4
11-26-2012 11:32 AM