I am wanting to get the Seibon Carbon Fiber front grille for the fit. I havent really looked around the bumper to see how hard it is to take off so i am wanting to know if anyone has either installed the Seibon piece or a similiar piece. If so any DIY's or some rough instructions?

 

I'm curious as well. I want one like the J's grille but without the rectangle piece. That's what this Seibon grille is, right?

 

Yeah. The sebion basically looks just like the oem piece with nothing in the middle. Its just like a carbon fiber "ring" you could say. Looks really clean though.

 

If you can pull the bumper it would make removing the grill way easier. The stock grill appears to be clipped in around the edges.

 

I pulled my grille out no problem by taking off the bumper clips just under the edge of the good. I could then slip my hand behind it. You might not be so lucky to have my small hands.

 

I'm going to try just removing my grille this weekend. Sounds like fun lol

 

Ya its really not that hard to remove the front bumper. then there are 2 screws. one on each side of the grill. then it just pops out.