TIR header installed-quiter exhaust!?
#22
Actually, depending on the header, you can gain low-end torque. I bought the T1R Response header, and it improves the low-end. Same with the Weapon-R header.
The T1R Power header, on the other hand, improves mostly the high-end torque, and so does the Megan header.
The T1R Power header, on the other hand, improves mostly the high-end torque, and so does the Megan header.
#26
Hey guys new here I drive an 08 VBP Fit Base 5MT. I am looking to to some minor modifications to it and the T1R header is on the list of headers I was looking at. I was just wondering if it has thrown a CEL for anyone? I need to keep it off to pass emissions tests.
#27
The T1R header has a bung for the factory O2 sensor. I installed mine and no light.
HOWEVER: Depending on the inspector, and the regulations in your area, you may not pass the "visual" portion of the inspection. The inspector may decide you don't pass because you modified something between the engine and the catalytic converter. You can reduce the risk of this by somehow attaching the factory heat shield to the new header to cover it. One guy took it to a muffler shop and had them weld some threaded rods to it and bolted the heat shield on that way.
HTH
Thread
Thread Starter
Forum
Replies
Last Post
SlowFit13
2nd Gen GE8 Specific Fit Engine Modifications, Motor Swaps, ECU Tuning Sub-Forum
2
12-11-2014 07:04 AM
xm8
2nd Generation (GE 08-13)
80
03-26-2010 01:13 PM
alexfree05
Fit Engine Modifications, Motor Swaps, ECU Tuning
10
04-04-2008 02:55 PM