Soo if I bought side markers...
#3
there might be a wrench meet sometime soon where we help each other out. you can wait it out till then. If you want it done soon check the jdm styling thread and there is a sticky with helpful info.
#4
LOL, here he is cutting the fender LOL. But the template we all succesfully used is from Eddie (lunar_gd3). Ask Eddie for a copy of the template and do NOT use any other than his cuz his works 100% for sure.
https://www.fitfreak.net/forums/fit-...tml#post442405
https://www.fitfreak.net/forums/fit-...tml#post442405
#7
These: JDM DC5 '02-'06 Integra/RSX Side Markers with Sockets (Amber) | JDM Honda Parts, JDM Honda Engines / JDM Nissan Motor Swaps, Used JDM Parts - Password JDM
or these:
JDM DC5 '02-'06 Integra/RSX Side Markers with Sockets (Clear) | JDM Honda Parts, JDM Honda Engines / JDM Nissan Motor Swaps, Used JDM Parts - Password JDM
and this:
Password:JDM City Light / Side Marker Wiring Harness | JDM Honda Parts, JDM Honda Engines / JDM Nissan Motor Swaps, Used JDM Parts - Password JDM
or these:
JDM DC5 '02-'06 Integra/RSX Side Markers with Sockets (Clear) | JDM Honda Parts, JDM Honda Engines / JDM Nissan Motor Swaps, Used JDM Parts - Password JDM
and this:
Password:JDM City Light / Side Marker Wiring Harness | JDM Honda Parts, JDM Honda Engines / JDM Nissan Motor Swaps, Used JDM Parts - Password JDM
#8
well get the right template from Eddie (Lunar_GD3) he will be glad to email you a properly sized template.
get some painters tape and put where you will be cutting.
Using the template, mark your hole carfully.
Now get a dremel and carefully and slowly taking your time start cutting. (measure twice, cut once)
now with up your harness to either your signals or park lights depending how you want them.
Snap in your sidemarkers and done.
*****What all of us did since I had some OEM touchup paint is we dabbed some on the hole to cover the metal where we cut to avoid future rust.
get some painters tape and put where you will be cutting.
Using the template, mark your hole carfully.
Now get a dremel and carefully and slowly taking your time start cutting. (measure twice, cut once)
now with up your harness to either your signals or park lights depending how you want them.
Snap in your sidemarkers and done.
*****What all of us did since I had some OEM touchup paint is we dabbed some on the hole to cover the metal where we cut to avoid future rust.
#20
haha im glad my photo of dan cutting into David's fenders really made it around on FF.
Dan is definately good at it and made it VERY level. If you measure/trace the template correctly dan will get it done. He does an even better job with a couple of beers first!
Dan is definately good at it and made it VERY level. If you measure/trace the template correctly dan will get it done. He does an even better job with a couple of beers first!