Zeebrah's Fit Sport: Eleanor.
#181
Finally got a new camera! Ended up getting the T4i
Thought I'd mess around with it a bit today to test it out so excuse the dirty car-- there's no hiding the flaws with this camera now haha; will be on the lookout for a nice spot to take pics once the c/o's come
Thought I'd mess around with it a bit today to test it out so excuse the dirty car-- there's no hiding the flaws with this camera now haha; will be on the lookout for a nice spot to take pics once the c/o's come
#188
Slang? Haha here's the url.
Emblem Overlays
These are just the vinyl, you have to have the red emblems already to put these over. I believe they sell emblems too but I didn't looked into it much.
#189
Thanks! I'm pretty satisfied with the Tanabe's. But if I was able to, I would have gone with Eibach Sportlines since I heard Eibach's felt softer, though I'm not sure how they compare to Tanabe's so I wouldn't know. I picked the Tanabe's because of my wheel & tire setup. The DF210's drop 1.3"(front) and 1.8"(rear). Ride is bumpy on parts of the freeway that aren't asphalt but it's bearable, haha. Front could be lower, but it was alright for me because I was rubbing like crazy until I got my fenders rolled. I'm pretty sure you'll be fine with Tanabe's since you've got stocks at the moment. And I'm sure you'll make a better wheel/tire decision than I did back then lol. I would suggest Eibach Sportlines though! I think I remember they have a 2" Front and 1.8" Back? It's the perfect stance on springs in my opinion other than the RSR's but the RSR's have a horrible ride from what I've read on the forum.
Slang? Haha here's the url.
Emblem Overlays
These are just the vinyl, you have to have the red emblems already to put these over. I believe they sell emblems too but I didn't looked into it much.
Slang? Haha here's the url.
Emblem Overlays
These are just the vinyl, you have to have the red emblems already to put these over. I believe they sell emblems too but I didn't looked into it much.
#190
Oh alright! My bad Didn't dig deeper with rsr's as much as the other springs. Good to know! Are they still a little harder to get like they were before though?
Edit: Oh, bruh! I meant the Super Downs though! (Or is there such thing?) The ones that drop like 2" all around or something.. they go crazy low.
Edit: Oh, bruh! I meant the Super Downs though! (Or is there such thing?) The ones that drop like 2" all around or something.. they go crazy low.
Last edited by Burzpaw; 04-22-2013 at 02:02 PM.
#192
I don't remember the part number, sorry. I bought it at Inlinefour because I was close to the store and they just matched the size to my oem H's. They told me they were EP3 front and DC5 rear but GrafiXpressions' measurements are different and told me I have the measurements for their "9th gen sedan" overlays.
#197
What it do!
Messed with the spoiler again. Still had the spoiler mod from before that could tilt the spoiler but this time I also raised the whole spoiler up a tad using washers(for now) on the 2 main bolts at the top. I didn't like the upside down "V" on the sides that separated the spoiler and the contour of the car so I used the washers to make the gap more parallel. Very subtle but I like it that way.
Inspired by the old maroon(accord) colored Fit that had a custom spoiler raiser-- planning on doing something like that to raise the spoiler higher once I have the time. Couple shots of what I tried explaining:
Inspired by the old maroon(accord) colored Fit that had a custom spoiler raiser-- planning on doing something like that to raise the spoiler higher once I have the time. Couple shots of what I tried explaining:
#199
Haha thanks, we'll see. I pretty much wanted the lines from the sideview of the spoiler to be horizontal so I'm leaning more on keepin' it like this but I'll definitely tilt it more for fun lol!