Rattling from outside triangle trim piece
#1
Rattling from outside triangle trim piece
I've been getting this constant rattling whenever I hit a bump or play any music with any hint of bass. I found out that its because there is a slight gap between the triangle trim piece above my passenger side fender. My driver side is perfectly snug and does not rattle at all.
How would I go about fixing this?
How would I go about fixing this?
#2
I have the same exact problem!! it took me awhile to figure out that it was that piece rattling... I unsnapped the piece, and put some electric tape on the clips, to prevent it from vibrating. It helps most of the time, but once in awhile I still hear it vibrating.
#3
How did you take that piece off? I'm slowly going insane b/c of this lol
#5
you can yank it off slowly... be careful not to break any of the clips though.... what I did was yank it off, then shove some electrical tape near the clips so that the piece would not move anymore.
#6
I was wondering the same, i was planning on covering my pillars in matching dark gray Alcantara material, that part being beige just drives me crazy..
Thread
Thread Starter
Forum
Replies
Last Post
ciref8
2nd Generation GE8 Specific DIY: Repair & Maintenance Sub-Forum
2
03-23-2013 04:41 AM
FightingChance
Fit DIY: Repair & Maintenance
1
12-07-2009 02:22 AM