What did you do to your GE fit today?
#7781
Maybe wrong thread, but these lug nuts on ebay look legit to you?
ebay: Kics Caliber 24 TI Blue Lock Lug Nuts 12x1 5 1 5 Acorn Wheel Rim Close 7 Sided L | eBay
real thing: KICS Project Heptagon Caliber 24 Blue Titanium Closed Ended Lug Nuts 12X1.50 at RallySportDirect.com
ebay: Kics Caliber 24 TI Blue Lock Lug Nuts 12x1 5 1 5 Acorn Wheel Rim Close 7 Sided L | eBay
real thing: KICS Project Heptagon Caliber 24 Blue Titanium Closed Ended Lug Nuts 12X1.50 at RallySportDirect.com
#7782
I know what you mean, the two piece design. I have some imitation Kics R40 that have that. Why do you say buy Muteki tho? They don't have two piece design and I've read the finish chips off on them.
#7784
progress rsb installed. short test drive around the block to make sure it doesnt fall off. lol. turns feel a little better. rear is more responsive. the right middle nut is a pain in the ass to tighten, still a little loose since i can't get my allen key in between the rubber and the bolt head. all the other ones are fine no problem.
#7786
^ Nice! I really wanna go w/ Kics. Want close ended this time tho. The Revo are nice, but seems a little crazy to spend that kinda $$$ on lug nuts. Leggdura are nice, but afraid they'll start chipping bad after a few goes with the lug wrench. The Caliber 24 are a bit long, but I'm leaning towards them right now...
#7787
#7790
Was it a DIY fix? If so, what did you use?
#7793
been wondering why i have to keep pumping air into my left rear tire every week, but not the others. when i jacked it up to install my rsb, i found a big screw lodged into the thread. so very glad it was in the thread not the wall. i had it plugged up. hopefully it stays good.
#7797
Armrest in normal mode
Armrest slid out
Back view
Armrest storage
Armrest in up position
Replacement screw. The black screw came with the armrest
Washer and machine screw. I drilled a hole where the armrest mounts to the car and used the replacement machine screw to secure the lower part of the armrest. When putting all the parts together make sure to put pressure on the screwdriver so it won't strip the plastic parts.
#7798
Today I picked up my Fit. Ordered up a few things from Bernardi (cargo cover, cargo tray and mud flaps).
Ran over a gnarley nail within a mile of picking it up, and it's a fat enough nail that it probably can't be repaired. I checked Tire Rack to see how much the tire is if the dealer wasn't willing to replace it - $117 a piece. Then I saw the reviews and ratings basically say how awful the base tires are, so I decided to order a set of 185/60/15 General Altimax HPs.
Ran over a gnarley nail within a mile of picking it up, and it's a fat enough nail that it probably can't be repaired. I checked Tire Rack to see how much the tire is if the dealer wasn't willing to replace it - $117 a piece. Then I saw the reviews and ratings basically say how awful the base tires are, so I decided to order a set of 185/60/15 General Altimax HPs.