what parts would you like to have available?
#81
Our upper mounts suck. Popped them in a while back when the suspension was stock. Eliminated low speed turning noise. I installed fittings on all ball joints too. Not the lower one.... endlinks and tierod ends. In my mind if it moves; it needs grease...period. What it is made of, does, and is exposed too determines the grease. I remember a time when fittings came on everything.
I'm rattling through shelves of parts and tools now. Have to straighten everything up so I can start fresh in my shop again, but I'll have some pics of the spring seats I speak of as well.
I'm rattling through shelves of parts and tools now. Have to straighten everything up so I can start fresh in my shop again, but I'll have some pics of the spring seats I speak of as well.
#83
Sorry I been crazy busy with this amazing internship. Here are a couple of pics of the upper spring seats. Notice how the shoulders disappear, thereby increasing the load per square inch of the torment we put on the upper mounts. We have to figure something out!!! The Cusco is not a better option. It places the load on the same location. Our stocks reach out and stabilize the camber/caster, and spread the force over a larger area of our chassis.
Last edited by Honda_chemist; 07-02-2013 at 09:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
TheDilweed
2nd Generation GE8 Specific Suspension & Brakes Sub-Forum
0
10-02-2012 10:36 PM