JDP Carbon Lip Installed!
#21
In response to the posters wondering what it would look like if the Sport molding were removed, I asked John at JDP the same question and he said the lip is made specifically to attach onto the Sport molding.
#25
Yeah. I had originally talked with John and he had me email him a pic of the lip. He then photoshopped markings on where to drill and emailed it back to me. But in the mean time I went ahead and drilled where I thought the bolts should have went and was pretty much spot on when I saw the pic in my email.
#34
I wasn't kidding ya when I told you that you would have to take the bumper off huh? Hope these help.
#35
Ya I don't care how good you are I think it's impossible to do it with the bumper on the car with those short a$$ bolts lol... Only took me few hours fml. But for some reason I'm looking at it and it's a tad bit higher one side if i look at the lines on the sport lip. Yours the same or no?
#36
Ya I don't care how good you are I think it's impossible to do it with the bumper on the car with those short a$$ bolts lol... Only took me few hours fml. But for some reason I'm looking at it and it's a tad bit higher one side if i look at the lines on the sport lip. Yours the same or no?
After looking at it for a while I too noticed that the right side (exhaust side) is just a hair higher. You can kinda see it in the very first pic I posted that is a direct shot of the rear bumper. I don't think that it is noticable unless you really look. I also found a couple of bubbles in the clear finish that I can see if I really inspect it.
Thread
Thread Starter
Forum
Replies
Last Post
benedictARNOLD
2nd Generation GE8 Specific Fit Photos & Videos Sub-Forum
38
05-13-2013 06:17 PM