The more and more I see base fits the more I want to strip off the lips on my sport.

They have that rally look to them.

loving the 949's as well.

 

So I had discovered a soaked carpet and a trunk full of water, so I did this.




I've been waiting for a decent day to try to seal the cracks in the roof, I did that yesterday, still have the carpet out to see if it's going to leak still. Also did this...

 

My driver side rear door leaks and I have had the panel off and attempted 3 times to fix. It still leaks. I just put a towel on the floor to soak it up. It rains a lot here. I sealed the ones on the roof to prevent the trunk from leaking. I hope you are going to be all good with your interior. Your rear disk conversion is mouth watering. GOOD JOB VERY NICE.

 

Received the Mugen rear view mirror cover in Milano Red and installed. Adds a nice pop of color to the Fit interior. Please don't mind my filthy Fit, gotta wash her soon.

 

Well I finally got flashpro figured out and took the car for a much needed drive. I got that emissions tune on and once I pass everything will be disassembled and getting ready for cage.

 

The same cage as before or a different one?

 

Same one. I blew the engine on my friends race car that I was driving and had to pay to put an engine in it. So all the money saved went to that. But I'll be getting the cage done soon. Haven't drove the car in a while so I'm going to drive it for a month or so and then back to the garage and disassembled.

 

Flushed my coolant

















6 flushes.

 

Flush it more than twice you're playing with it.

 

I think that grill would look a whole lot better on my car lol jk, looks good

 

My car passed emissions! !!! Woot! It's only been expired since july

 

May i ask where did you purchase that cover from?

 

Here you go dude:
Mugen Rear View Mirror Cover 76450-XK7C-K0S0

 

You might be able to get them from icb Motorsports

 

Echo echo echo!

 

Thank you for the info.

 

thank you for the info

 

Had a rattle at 2500rpm that's been driving me nuts, found it was the one on the cat so I unbolted it and cut the metal around the sensor so it can just be pulled off. One of the bolts had no contact with the top heat shield (looks like the pieces separated) so I trimmed it, bolted it back up and no more rattle.
I could have just left the shield off but my luck I would have to park on grass tomorrow and light everything on fire, that cat gets HOT.
Also fixed my driver side fog light, works perfectly now.

I need a new exhaust from the header to the muffler, an intake, maybe the intake manifold, hondata and a tune.

 

Earlier this week:

 

I installed front and rear Tokico HTS shocks/struts(Swift springs already on there). Stuck the camber bolts in and put some RE-71R tires on my extra wheels, headed to autox tomorrow, should be fun. Nothing like changing everything and then trying not to drive like an idiot.